We have been renovating an 80's home with a vaulted roof in the living/kitchen/dining area, something like your picture. We needed to make the space look bigger so we opted to hang our tv from the roof using an Adtec tv bracket in white, pretty nifty unit, all wiring, aerials etc go up the mounting pole and through the roof. The unit also swivels 360 degrees which is great for any view point in the room, including our outside area. We had a tv unit custom built by Jarramar Furniture which is like a rather large floating cupboard. The unit has 2 draws and one cupboard. All the cords etc come down the wall in the adjoining room behind the door, neatly packed into duct and back into the back of the floating cupboard. It's very neat and tidy, keeps everything off the ground and makes your space look bigger. Both Adtec and Jarramar have websites where you can check out their stuff. You just need to ensure your tv weights are ok for the Adtec unit your wish to purchase. Good luck with your design.

There is a lot of paste and size residue still on the walls. Washing and scraping helps but it still feels like it's there. Would a good sanding be sufficent or do I need to wash all the paste off before painting?

I need help trying to secure a pallet between two posts to make a wall to block wind and tree debris, as it floats through the door The posts are already in place, as they are the posts that hold up the outdoor covering. I just discovered that the posts also have a steel rod going through them (vertically), so I cannot bolt/nail through the posts. Also, the pallet is not a perfect fit between the two posts. Any suggestions?

We are renovating a block basement. As the block wall has earth behind it outside, we went for internal floor and wall waterproofing. The plan is to strap out the block walls to keep the wall lining off the waterproofing membrane and enable wiring to PowerPoints. I'm now wondering if we should have gone for foam insulation in the block walls before waterproofing. Does anyone know if the expanded foam can be injected from outside into the concrete block wall above ground level as I understand this is a better approach than insulating between plasterboard and concrete block wall. Thanks