kate_kedward

Sink mixer help needed

Keddie K
5 years ago
Hello, we’re embarking on a full kitchen reno and I’m struggling to decide on the sink mixer. Ideally I’d like a goose neck with pull out nozzle, but after reading posts on Houzz it sounds like they may not wear too well. Does anyone have experience or advice around this?

We’re considering this Meir black gooseneck as they do electroplated coatings which I believe wear much better than standard black coating. However I’m not sure I love the wider to narrower look.

If we don’t end up with the pull an alternative is one of the following two photos - any preferences on which?

We’ll have matt black lower cabinets separated with wood veneer edging (a similar look to the fourth photo), Silestone blanco matrix benches, upper cabinets in Bestwood Ranfurly Oak melamine, probably a black stainless steel sink and a wood-look LVT floor (colour yet to be confirmed).

Any advice or alternative tap options gladly welcomed (we’re in NZ but I don’t think it’ll be an issue to get taps shipped here).

Comment (1)