When installing over top of old ceramic/porcelain be aware that you will most likely have to "sink" the old tiles in cement to do this. That means grinding down the tiles a little (rough up the surface) then the self leveling cement is poured and allowed to dry. The new floor is then laid over top. Vinyl is notorious for requiring EXTREMELY flat surface. A ceramic tile rarely has this requirement (grout lines and "high spots" around tile corners give problems). A glue in place tile is also going to have the same problems and the same solution = sinking the tiles in cement. This adds extra costs to the floor. A rigid floor like a cork floating floor can handle a bit more floor deflection than vinyl or laminate planks. If labour in your area is relatively cheap...you could probably have the tile removed and the sanding of the mortar done for the same price as coating in concrete. You will also have the luxury of being able to lay any floor you want once it is done AND you don't have to worry about increasing the floor height. It is possible to sink the ceramic in cement...but is it the most cost effective option? Maybe not.

Thanks :) Yeah decided to go with tile. So sand cement is ok over existing tiles if I prep them first? Only problem is, the new pad can only be about 30mm at it's thickest (leaving up to 15mm for tiles) otherwise it'll end up being higher than the hallway floor. So I either need to make the fall shallower or not bother with the waste and make it all level. If I made it level, could I use levelling compound at that thickness or would deck mud/sand cement be the best option? Also, should I be putting in mesh for strength? (I know I should (and will) ask the local hardware what they suggest, but it's great to have suggestions from the Houzz community also)

Thanks everyone for the warnings. Honestly I had not thought that could be possible so just in case I'll gear up with a mask to avoid inhaling any of it. I will still need to remove it, but from what I read the problem with asbestos is if you sand it and make it into breathable particles, so ripping it out should be ok. I've looked up in youtubr and there seems to be a tool called mastic remover that you can put on your floor sander and it would scratch the surface removing any of that stuff.

I think it would make both rooms too dark. Maybe go with a lighter floor colour?