I would suggest you take out the cabinet that is to the right of the stove and use it elsewhere in the house -- perhaps in the bathroom or dining room with a hutch above it. Then, I would suggest you have someone install a lazy susan cabinet in the corner between the sink counter and the stove, meaning you would move the stove down a bit and have a small cabinet/counter top to the right of the stove. I would suggest you have the cabinets refinished in white and then paint the walls a pastel you like. If you would prefer white walls, then add white-painted crown molding and paint the ceiling a light neutral blue, such as Sherwin Williams Niagara Falls Blue. Then, I would suggest you choose a favorite accent color and use this sparingly in accessories like towels, pot holders, small vases or floral arrangements, and a valence above the triple windows. For a genuine 1940s look, you might have white ceramic square tiles with a rectangular red border installed as a back splash behind and above the stove. If you are replacing counter tops, I would suggest a light color such as white with a beige or light grey vein or striation for some sort of pattern. You might be able to find the same color and design in floor tile OR opt for a wood floor as another poster suggested.

Bring the window down to meet the cupboard. Really lefty47 was right about not drawing attention to it. It is a source of light ,,, so no need to clutter it up. But if you took the colour out and painted the top of the cupbard to match the wall it ceases to draw attention to itself. Just because it is a horizontal space does not meant it needs something put on it. Note- With the cupboard being white, it also draws attention to itself … perhaps take that to the wall colour too and lift the pendant a smidge. So your pendant is the feature there. The cupboard … do yo need it? One way to remove what you are calling dead space is to get rid of the cupboard.

Thanks :) Yeah decided to go with tile. So sand cement is ok over existing tiles if I prep them first? Only problem is, the new pad can only be about 30mm at it's thickest (leaving up to 15mm for tiles) otherwise it'll end up being higher than the hallway floor. So I either need to make the fall shallower or not bother with the waste and make it all level. If I made it level, could I use levelling compound at that thickness or would deck mud/sand cement be the best option? Also, should I be putting in mesh for strength? (I know I should (and will) ask the local hardware what they suggest, but it's great to have suggestions from the Houzz community also)

I read an interesting comment somewhere, where a lady invited a group of her friends over to lovingly point out all the problems they saw (through fresh eyes) with her home on preparation for sale. She said she was surprised at marks and damage that she had lived with for so long she no longer noticed them. We "owner built" a home previously, and when we came to sell 7 years later, we painted the garage and did those jobs that we had put off, and it became sad to finally see her at her best, at the end, when we could have been living in a completely finished home all that time. I read about a lady who decluttered her home, had it professionally cleaned (build clean, or bond clean) and had a professional styler do her home and she realised just how nice it could be and decided not to sell. :) ta