This made me laugh: http://www.theguardian.com/environment/2016/jun/09/seagull-turns-orange-after-falling-into-vat-of-chicken-tikka-masala I couldn't copy the picture, but it's hilarious.

We have that exact sink! And a very small powder room stuck in the 80s. Only difference is our door is on a side wall, and there is no window. We're no where near finished, but just ripping down the pink floral and stripey wall paper has made a huge difference (including revealing the toilet is in fact white, not pale pink). We're going to replace the rather unappealing plastic sink with a tiny ceramic one with new taps, and the old plastic cistern with a new colonial style ceramic one, and new seat (keeping the toilet base as it is in good condition, and classic style). Then new paint, and a good clean and regrout to the floor, new light shade, toilet roll holder, storage in one corner and art.

I love the look of Tand G as the real thing or the 'James Hardie' NZ groove panels..........but also want my ensuite to look opulent. I am not having tiling anywhere in this room, which would be the easiest solution. Hence my dilemma..... I already have chosen the white 'tile look' acrylic walls with a feature 'marble' (narrow) panel in the shower alcove enclosure from the 'Atlantis' range. The alcove covers the complete width of the bathroom so is a feature in itself. I wanted to bring the 'marble 'feature' into the room if I could to enhance the opulence. The marbling is minimal veining on a white background so not too dramatic a feature. The obvious area is to use a matching 'marble' vanity top and/or a splash back (especially if have a china vanity top, which is the more likely due to cost). Where should the splashback end at the sides? I thought about taking the 'marble' splashback above the mirror to the ceiling thus creating a similar panel feature to that in the shower albeit wider but don't know how much wider it should be than the vanity. Also What then to do on the rest of the wall(s)? Just painted gib? If I used T& G or groove panelling I would want it to reach the ceiling. So do I put T&G on on all walls? The vanity wall has approx 1000mm 'strips' of full wall either side and the strips below the vanity and above mirror if only a splashback is incorporated. The opposite wall is almost taken up by window, radiator below, btw toilet and towel rail, leaving little wall to 'feature' and then the remaining wall is narrow (only 1100 left after door). These remaining walls could just be left as painted gib of course as really cannot afford to take the 'marble' panelling anywhere else in the room nor think where else it would feature best. 'Marble' Flooring is a possibility but it would need to be vinyl not porcelain tiles. Having written all this down I think I have talked myself out of T&G on any of the walls as the narrow room would become too busy and bitty but am still interested in what others think.

Hello, I am hoping to get some ideas for reconfiguring the lay out for my 1950’s home I’ve purchased if anyone can help please? I am single, live alone and it will be my ‘forever’ home and has great views of the Tauranga harbour which I want to make the most of, of course :) Any ideas for one or all requirements are gratefully accepted thanks! They are as follows: 1. A new ensuite and walk in robe off the side of the front bedroom beside the lounge as I want that to be my bedroom with a view. There is sufficient room to build along the outside of that side of the house toward the boundary; the ensuite to face the view please. Perhaps change the entrance door to that bedroom off the hall way somehow? 2. Reconfigure a new kitchen; the existing one is quite skinny and there is really only room for one person between the bench and the return bench. No room to build out from that side of the house, but the deck is huge. I have considered building out over the deck but assume it would involve a lot of $ as would require engineers reports etc. The deck is a solid (old) concrete roof over what is now a block basement which used to be the old garage. 3. To somehow join the existing garage up to the house so I have internal entry from that. In the ‘joining’ space somewhere is where I envisage the front entry way with some storage cupboards etc as the house has almost no storage. The existing garage is an old tin one and needs to be replaced. It is also raised higher than the house level and there is as retaining wall between the garage and the house. Ideally I’d like to dig it all out and make it one level but that will be dictated by finances. However, I've been unable to work out how to join them if they are different levels - aesthetically wise. There would have to be steps down (which I don't really want if I’m getting old here…) so how would the roof line look right? 4. Reconfigure/Remove the existing toilet and/or bathroom as presently the main door into the house comes inbetween these and I don't want the entrance right beside the toilet - eek! The existing bathroom is also the laundry. My thoughts were to move them in to either bedroom 2 or 3, and extend to get another bedroom somehow, or, put them at the back of the new addition joining the garage to the house somehow? 5. The lounge and dining room have alcoves built in that serve no real purpose; both the dining and lounge could be larger if possible. I want to put my couch along the wall which backs on to the dining room so I can look at the view while watching TV etc. I’m not overly keen on open plan so thought I could build a wall there and move the entrance to the dining closer to the hall end of the lounge? 6. To retain 3 bedrooms, one to be used as an office. I am very grateful for any ideas anyone could put forward - many thanks in advance :) Unfortunately the website will not allow me to upload photos so I will have to contact them to see what is going on - sorry!