I would suggest you take out the cabinet that is to the right of the stove and use it elsewhere in the house -- perhaps in the bathroom or dining room with a hutch above it. Then, I would suggest you have someone install a lazy susan cabinet in the corner between the sink counter and the stove, meaning you would move the stove down a bit and have a small cabinet/counter top to the right of the stove. I would suggest you have the cabinets refinished in white and then paint the walls a pastel you like. If you would prefer white walls, then add white-painted crown molding and paint the ceiling a light neutral blue, such as Sherwin Williams Niagara Falls Blue. Then, I would suggest you choose a favorite accent color and use this sparingly in accessories like towels, pot holders, small vases or floral arrangements, and a valence above the triple windows. For a genuine 1940s look, you might have white ceramic square tiles with a rectangular red border installed as a back splash behind and above the stove. If you are replacing counter tops, I would suggest a light color such as white with a beige or light grey vein or striation for some sort of pattern. You might be able to find the same color and design in floor tile OR opt for a wood floor as another poster suggested.

~$400 including expedited shipping. My GC just had his regular countertop guy do them, which wasn't great.... he had trouble making clean cuts. If I were going to do it again I would have pressed for someone with expertise to cut them. You can see in the image that the facing is not made of the stone peak, because too much was broken during the cutting to make the mitered edge. I'm a little bummed, but mostly pleased with the surface (which is the important part) thus far.

Love blue tiles. Depending on how much sun and how hot your pool gets in the summer should dictate what color it is. We live in Arizona, so cool blues work best. Our neighbor has brown tile and a dark pebble tech pool. Looks like a swimming hole and gets really hot - 94% water in the summer. They obviously didn't think it through.

Thanks :) Yeah decided to go with tile. So sand cement is ok over existing tiles if I prep them first? Only problem is, the new pad can only be about 30mm at it's thickest (leaving up to 15mm for tiles) otherwise it'll end up being higher than the hallway floor. So I either need to make the fall shallower or not bother with the waste and make it all level. If I made it level, could I use levelling compound at that thickness or would deck mud/sand cement be the best option? Also, should I be putting in mesh for strength? (I know I should (and will) ask the local hardware what they suggest, but it's great to have suggestions from the Houzz community also)