Hello There: Your home looks like it has some good bones and period features. No one has yet to comment on marrying subway tiles on lower walls, with tongue and groove cladding on upper walls of your space. I am thinking this finished look could well end up looking quite "busy." Lots of competing "grid" lines, etc. If I understand correctly, this space is actually, or ultimately will be, a bathroom. Perhaps you do not want a wood product on lower sections of the walls because of potential water damage, etc. That said, there are excellent paints, sealants, etc., that you could apply that would guard against this. If painting, using Zinsser Sealant as base coat is a good starting point. As another alternative, you could use much larger tiles on lower portion of walls, oriented vertically. I am thinking 12" x 18" (or 24") tiles. Of course, these are more challenging to install, given their greater size and therefore, weight. Despite this, if you have an excellent tiler, it can definitely be done. For example, you could choose glass tiles, either clear or coloured. Going even further, you could install glass panels to lower sections of walls. You could "back paint" them or not. You could apply paint or even wallpaper (with a wonderful design and colour way you'd likely never tire of) prior to installing glass panels. The wallpaper idea, especially if design is more curvilinear in nature, would not be competing with verticality of tongue and groove, but rather, would complement and enhance it. If beautiful wallpaper (or heck, even a mural or timeless design could be painted directly on walls) is applied and then covered with clear glass panels, the overall effect would be akin to that of an art installation. Naturally, glass panels would be considerably more expensive, but would provide a more seamless, less cluttered appearance. Should you like this idea, simply check what thickness of glass would work best, both for aesthetic and safety purposes. If you have a bit of time to shop around for best supplier and price point, you could well suss out a source that will not "break the bank!" :) To affix glass panels to the walls you want to use hardware that is anodized. As an idea, you could use anodized lug nuts that are usually used for automotive purposes. I just looked up "anodized lug nuts" and see they are available in wide array of wonderful, decorative colours. This hardware would be visibly holding your glass panels in permanent place, but they would be a small attractive design element, ultimately adding another layer of visual interest to your space. I believe glass panels would tie in very well with your great, textured/mottled glass panelled door and transom. Too, I think the overall look would achieve a really attractive marriage as various materials, along with period architectural features would "read:" old, new, and timeless. I realize this design concept may seem counterintuitive to you and/or others, but I can "see it" and think it could be just fab! All The Best, Sharon Black, interior designer and contractor

congrats! first, sand prime and paint out those cabinets....i'd go with a grayish shade of white or pale gray that will work with the flooring. i'd also carefuly chip off the yellow tiles. since on a budget, consider applying some beadboard as your backsplash, painted in a glossy, oil based or marine paint in a crisp white to keep it scrubbable, then, dress up the edges with some small mouldings, painted in the same white paint. this is going to be SO MUCH less costly than tile! and it will look great with the butcher block countertop. you can probably refresh the butcher block with a light sand and oiling. you could even get an additional piece of butcher block (ikea) and create a step-up 'bar' for some stools on the peninsula for some casual seating. then get a pair of pendant lights to hang from the pot lights above (they make lights that insert directly into the pot light...no hardwire necessary).

Your suggestions are really greatly appreciated. My town house unit is under complete exterior re-cladding works, prompting quite substantial interior makeover (i.e installtion of ducted air con, replacing wall to wall carpet with timber upstairs, and tiles in open space downstaris, replacing creamy wall paper will be replaced with neutral white paint. So my green kitchen with creamy formica counter (bench) top should go. I don't hate green simply had egounh of it after long 15 yeras! My small U shape kitchen is due for complete makeover, I think! I'll probably go with new cabinets (lower one for microwave) up to the ceiling, when move fridge at the end I'll go with panel with matching colour up to the ceiling, expanding counter top on the other side to the fridge. I guess that removal of the cupboard can be compesated with extension of the counter top so we can fit 3x drawer underneath and cabinets up to the ceiling can provide some useful storage space. Backsplash in same white palette or darker in contrast? Your kind ideas please!

Wow! What an incredible view you have! I think you first need to frame it out. I would suggest changing out the carpet with hardwood floors with a worn or weathered look. Definitely get rid of the plastic and replace with white base moulding. Next I would paint the walls a color in the pale grey or grey/blue family. Next, I would suggest some crisp white sheers to frame each window. In the pictures, it looks like the Windows on the right are two windows wide. If so, I would also place panels in the middle of those 2 windows to continue framing the view. These are for decorative purposes only and not intended to distract from the view. It looks like there is a big space between two of the windows. I would locate a large architectural piece to place on that wall to add some interest. Remove all the small items from the window ledges. Finally, I would love a round table in that space. Good luck with your reno!