The floor and cabinets almost look like the same color. I would lighten the cabinet color - making sure it doesn't clash with the floor color. I would also modernize the open cabinet above the microwave by removing the moulding, or adding a door. I'd find an inexpensive countertop that pops against the wood (or painted) wood cabinets. Change out the cabinet glass to clear, and do a new backsplash that brings it all together. And, finally add a cool light fixture, and maybe a kitchen rug.

Hi everyone, we have moved in! We didn't manage to paint before we moved and think we will go for a staged approach - above the wood panels first in a warm white then decide on the panels. I'm having a bit of trouble working out what kind of sofa to buy and how at arrange the lounge. All furniture except coffee table temporary in photos and would love some ideas!

~$400 including expedited shipping. My GC just had his regular countertop guy do them, which wasn't great.... he had trouble making clean cuts. If I were going to do it again I would have pressed for someone with expertise to cut them. You can see in the image that the facing is not made of the stone peak, because too much was broken during the cutting to make the mitered edge. I'm a little bummed, but mostly pleased with the surface (which is the important part) thus far.

Hi Jess, Unfortunately it probably wont stop doing this, as the timber join is butted together that join will always move given the nature of timber. A solution but might not be a cost effective solution would be to router the underneath of the join out with timber and glue in some more timber to help hold the join (a patch kinda thing) this will make the join stronger (assuming this hasn't already been done) Then we only recommend either a oil or wax finish if you want it to be left with a natural look or we apply a clear epoxy resin finish, this is a very good product (about 2-3 mm thick) and it lets the timber move a little and the product moves with the timber rather than crack like the lacquer seems to do. We pretty much always have the same result with kitchen benches when it comes to the sink area and joins. The main cause I see happening is that the timber moves (and it will never stop moving) and then if the lacquer is not flexible it will split open causing a spot for moisture to get in and under the lacquer making it go all funky like that A easier option would be to sand the tops and apply a oil and keep maintaining it, then you will never get the funky cloudy stuff happening, but you will need to do some research on what product are best and available where you are Good luck :-)