I would suggest you take out the cabinet that is to the right of the stove and use it elsewhere in the house -- perhaps in the bathroom or dining room with a hutch above it. Then, I would suggest you have someone install a lazy susan cabinet in the corner between the sink counter and the stove, meaning you would move the stove down a bit and have a small cabinet/counter top to the right of the stove. I would suggest you have the cabinets refinished in white and then paint the walls a pastel you like. If you would prefer white walls, then add white-painted crown molding and paint the ceiling a light neutral blue, such as Sherwin Williams Niagara Falls Blue. Then, I would suggest you choose a favorite accent color and use this sparingly in accessories like towels, pot holders, small vases or floral arrangements, and a valence above the triple windows. For a genuine 1940s look, you might have white ceramic square tiles with a rectangular red border installed as a back splash behind and above the stove. If you are replacing counter tops, I would suggest a light color such as white with a beige or light grey vein or striation for some sort of pattern. You might be able to find the same color and design in floor tile OR opt for a wood floor as another poster suggested.

~$400 including expedited shipping. My GC just had his regular countertop guy do them, which wasn't great.... he had trouble making clean cuts. If I were going to do it again I would have pressed for someone with expertise to cut them. You can see in the image that the facing is not made of the stone peak, because too much was broken during the cutting to make the mitered edge. I'm a little bummed, but mostly pleased with the surface (which is the important part) thus far.

We used corrugated metal for our woodstove surround -- talk about a gathering place for dirt! We just use the shop vac around the bottom to clean up. We don't have any dogs, but I'd imagine that it would collect just as much fur as any place where the wall meets the floor. We also have a bit of an accent area in our kitchen with the metal as well -- it is harder to clean with the floor vacuum, but any nozzle attachment gets the job done in a snap.

@Tribbletrouble44152k7 Trek, no not necessarily.. it fulfills it's purpose if you buy the one that is correct for what you want it for.. a bit of a catch22 and up to the store to point out that the thin stuff may dent.. in fact any of it can... there are many things that will void warranty of laminate floors.. here is a good website dealing with the cleaning and care .. http://www.baneclene.com/articles/laminate-care-consumer.html Remove shoes with spiked or damaged heels before walking on the floor. Spike or stiletto high-heel shoes may cause denting and related damage to wood floors due to the extremely high compressive force they generate. Such footwear can produce dynamic loads in excess of 1,000 pounds per square inch, even when worn by someone of slight or average build. Worth reading the whole thing.. Just worth reminding people that laminate flooring is mdf with a picture of wood printed on the surface with a couple of protective layers of clear coating over the top..it cannot be wet or steamed.. it will swell. Make sure you ask questions.. Wood vinyl planking is very durable and hardy, and bamboo is considered to be one of the strongest timbers.. if you choose to have floors redone with any of the above products please look them up on google and find out the qualities.. I vote for wood vinyl.. looks brilliant, can float or be glued (recommend glue for wet areas such as bathrooms, laundries) is hard wearing and cost is comparable with mid range wood laminate flooring and hardier. Hope that all helps. If you must have wood laminate then go for 10 - 12 mm.. anything less will flex. Must have underlay and be laid on a level floor.. There are self levelling compounds you can use to make this easier... hope all this helps.