As much as I like wood, I think you have too much in that area. You don't mention a budget limit, but to modernize the look, I would recommend replacing any louvered doors with solid doors. Painting the pantry's wood, trim, doors and your cabinets a color would lend it an updated look.

When installing over top of old ceramic/porcelain be aware that you will most likely have to "sink" the old tiles in cement to do this. That means grinding down the tiles a little (rough up the surface) then the self leveling cement is poured and allowed to dry. The new floor is then laid over top. Vinyl is notorious for requiring EXTREMELY flat surface. A ceramic tile rarely has this requirement (grout lines and "high spots" around tile corners give problems). A glue in place tile is also going to have the same problems and the same solution = sinking the tiles in cement. This adds extra costs to the floor. A rigid floor like a cork floating floor can handle a bit more floor deflection than vinyl or laminate planks. If labour in your area is relatively cheap...you could probably have the tile removed and the sanding of the mortar done for the same price as coating in concrete. You will also have the luxury of being able to lay any floor you want once it is done AND you don't have to worry about increasing the floor height. It is possible to sink the ceramic in cement...but is it the most cost effective option? Maybe not.

This is where the kitchen is going to be. Where my husband is will be counter top at that height. with a big wide counter top to sit under. on the back wall double door fridge a metre gap. 2 wall ovens then a sliding door where the ladder is. A scullery. Behind my husband to the side of him a sink the cooker then space. Where the big flat plank is on the ground (ish) will be the movable island. you can see a taster of the stone wall which will be on both sides of the entrance hallway, the flooring will look very similar to this http://carpetdiscounters.co.nz/product.aspx?product_id=441 . You may note the steel next to my husband on that side. it also needs to be treated. Thank you very much

@Tribbletrouble44152k7 Trek, no not necessarily.. it fulfills it's purpose if you buy the one that is correct for what you want it for.. a bit of a catch22 and up to the store to point out that the thin stuff may dent.. in fact any of it can... there are many things that will void warranty of laminate floors.. here is a good website dealing with the cleaning and care .. http://www.baneclene.com/articles/laminate-care-consumer.html Remove shoes with spiked or damaged heels before walking on the floor. Spike or stiletto high-heel shoes may cause denting and related damage to wood floors due to the extremely high compressive force they generate. Such footwear can produce dynamic loads in excess of 1,000 pounds per square inch, even when worn by someone of slight or average build. Worth reading the whole thing.. Just worth reminding people that laminate flooring is mdf with a picture of wood printed on the surface with a couple of protective layers of clear coating over the top..it cannot be wet or steamed.. it will swell. Make sure you ask questions.. Wood vinyl planking is very durable and hardy, and bamboo is considered to be one of the strongest timbers.. if you choose to have floors redone with any of the above products please look them up on google and find out the qualities.. I vote for wood vinyl.. looks brilliant, can float or be glued (recommend glue for wet areas such as bathrooms, laundries) is hard wearing and cost is comparable with mid range wood laminate flooring and hardier. Hope that all helps. If you must have wood laminate then go for 10 - 12 mm.. anything less will flex. Must have underlay and be laid on a level floor.. There are self levelling compounds you can use to make this easier... hope all this helps.