Hi there- beautiful railing! We are doing something similar and I’m curious what method you used for drilling accurate holes for the cabling through the cross beams.
Craftsman Cross-Brace Metal Cable Rail · More Info
We create detailed drawings and determine the holes pre-fabrication. We are able to dimension the cross-braces individually and specify each hole location. Then it's in the hands of our skilled team on the shop floor. You can drill perpendicular to the surface and create a pocket, and then go in on the angle. Depending on your slope, you can also start in perpendicular and then slowly angle your bit out. Where you start your holes with either of these methods will depend on your layout (centerline vs edge, etc.).
Drilling these angles is not easy. Another reason this is one of our top-of-the line railing designs! Best of luck on your project.
Great Lakes Metal Fabrication
Related Discussions
A suitable topic to share ideas for projects on a budget
Q
What to do with the bathroom vanity hole?
Q
Vanities without pre-drilled holes for taps
Q
Is this vent installed ok? Picture included.
Q