Thanks for posting new views of your room. You are right, nothing can go in front of the paneling, and we won't block the built-in cubby. In that case let's work with the rest of the space. I found a picture on Houzz for your gallery wall. I think this will allow you to bring in color and texture and interest to your wall without taking up space like furniture would. Try to play with portraits and a couple of paintings in there too - mix it up. Otherwise I would not put anything at the top of that landing (I'd remove that console table). That picture wall should be enough visual interest to your space and it'll draw the eye to the furthest wall as you walk in your house. I would try a small piece with closed storage between the bottom steps and that door by the entry. It looks like the space is no wider than 26", so it'll be a challenge to find something that fits and is tall enough. I would not use the wooden piece you showed above because you want wider proportions and fairly narrow depth so you don't bump into it as you walk by. (something like this ) I would hang a mirror on top of primping. By the cubby you could add a single seat stool. I'm not particularly suggesting these colors for the stool and bombe chest but something along these shapes. At this point if you do that big picture wall and add these two pieces of furniture and a mirror, you might not need to hang anything on the wall above the cubby. Also, I noticed your chandelier is quite substantial for the space and hanging pretty low. Would raising it a little or replacing it by something a little smaller be an option?

As chookchook said in her recommendation about painting, put a drop cloth on the floor. Get a very safe ladder. remove the lightbulbs, and cover the outlets. Turn off the electricity to the chandelier. Then spray it with a mild cleaner (I use one I found at Target that's basically water with vinegar, until it's dripping wet. Start at the bottom and work your way up, so you don't have dirty spray dripping on the bottom of the chandelier.Work your way up and down until the dripping spray is clean. The chandelier may be gorgeous and expensive, but it seems totally out of place in the architecture of the room--more at home in a chalet than a sunny room with a window wall. I would probably try to find a way to get it removed, and sell it to someone who appreciated it better than I.

~$400 including expedited shipping. My GC just had his regular countertop guy do them, which wasn't great.... he had trouble making clean cuts. If I were going to do it again I would have pressed for someone with expertise to cut them. You can see in the image that the facing is not made of the stone peak, because too much was broken during the cutting to make the mitered edge. I'm a little bummed, but mostly pleased with the surface (which is the important part) thus far.

Thanks :) Yeah decided to go with tile. So sand cement is ok over existing tiles if I prep them first? Only problem is, the new pad can only be about 30mm at it's thickest (leaving up to 15mm for tiles) otherwise it'll end up being higher than the hallway floor. So I either need to make the fall shallower or not bother with the waste and make it all level. If I made it level, could I use levelling compound at that thickness or would deck mud/sand cement be the best option? Also, should I be putting in mesh for strength? (I know I should (and will) ask the local hardware what they suggest, but it's great to have suggestions from the Houzz community also)