webuser_464329257

What floor leveller would be right for my job

Libby Stano
last year
last modified: last year

I have a small workshop with an uneven concrete slab that I would like to level up.

My room is 2.4 x 2.9 = 7.2 sq mtr

The height range of the floor is from 1mm to 20mm

I don't want to use the leveller as a substrate. It will be the finished surface.

Because the room is small my tools live on mobile cabinets with hard plastic wheels. I can roll my planer/thicknesser, tablesaw etc into position (in the centre of my room) when I need to, so the leveller needs to finish hard as it will cop a bit of a beating at times.

Specially if I have to drag something over the surface.

I would also prefer the compound to do as it says and "self level". I haven't done this job before and there will be no point in trying if I can't get a level finish.

The alternative is to have it professionally epoxied and get the garage done at the same time ($$$$$?)

Any advise would be greatly appreciated.

Regards

Libby Stano

Comments (4)