@thinkforothers, Ha-ha that's so funny about your American trip but yes I use the duvet as a top sheet. As for getting the dooda back into the cover, I have a pretty simple method and it doesn't take allot of effort nor does it include being swallowed up by the duvet in the process as you said ha-ha..... but there is a bit of back and forth around the bed. I flick the duvet open onto the bed, I grab the one corner of the doona head up towards the respective corner and pull the duvet back towards my hand a little too and place it down, repeat on the other side, then I grab each top corner seperately holding the doona firmly in the corner and pull it up to the headboard, whilst walking back to the end of the bed I lift the cover slightly, allowing the doona to get further swallowed up by the cover, then I'm left with slipping either corner of the doona into the duvet. I do up the buttons then holding the bottom of the duvet, I flick the cover, towards the headboard, so that the doona edges forward in the cover and even flick the doona on both sides of the bed left to right and vice versa and it's usually perfect. Its very easy doing a single doona by again spreading the duvet over the bed, grab the doona corners, one in each hand, walk them up to the corners, lay it down then pick up the dooda by the top corners and shake a few times just straight down, even stand on a safe stool or on the bed and you will usually find the duvet with eaze it's way down with just the bottom corners to slip in and again voila!!! Unfortunately, when I bought two of my duvet sets from Ezibuy, I bought NZ king which is a bit wider that an Australian king size and I didn't know that at the time and I have a bit of slack on the sides but it doesn't cause any problems and what I mean by this is, that the doona doesn't slip all the way to the left or right, it does stay in place. Hope that explanation was clear, I should do a video ha-ha Cheers, Barbara

This made me laugh: http://www.theguardian.com/environment/2016/jun/09/seagull-turns-orange-after-falling-into-vat-of-chicken-tikka-masala I couldn't copy the picture, but it's hilarious.

@Tribbletrouble44152k7 Trek, no not necessarily.. it fulfills it's purpose if you buy the one that is correct for what you want it for.. a bit of a catch22 and up to the store to point out that the thin stuff may dent.. in fact any of it can... there are many things that will void warranty of laminate floors.. here is a good website dealing with the cleaning and care .. http://www.baneclene.com/articles/laminate-care-consumer.html Remove shoes with spiked or damaged heels before walking on the floor. Spike or stiletto high-heel shoes may cause denting and related damage to wood floors due to the extremely high compressive force they generate. Such footwear can produce dynamic loads in excess of 1,000 pounds per square inch, even when worn by someone of slight or average build. Worth reading the whole thing.. Just worth reminding people that laminate flooring is mdf with a picture of wood printed on the surface with a couple of protective layers of clear coating over the top..it cannot be wet or steamed.. it will swell. Make sure you ask questions.. Wood vinyl planking is very durable and hardy, and bamboo is considered to be one of the strongest timbers.. if you choose to have floors redone with any of the above products please look them up on google and find out the qualities.. I vote for wood vinyl.. looks brilliant, can float or be glued (recommend glue for wet areas such as bathrooms, laundries) is hard wearing and cost is comparable with mid range wood laminate flooring and hardier. Hope that all helps. If you must have wood laminate then go for 10 - 12 mm.. anything less will flex. Must have underlay and be laid on a level floor.. There are self levelling compounds you can use to make this easier... hope all this helps.

Mine is my living room - calm, sunny, relaxing, full of treasures (including my animals) and a cozy fire in the winter. The view is also amazing from my large comfortable arm chair.