~$400 including expedited shipping. My GC just had his regular countertop guy do them, which wasn't great.... he had trouble making clean cuts. If I were going to do it again I would have pressed for someone with expertise to cut them. You can see in the image that the facing is not made of the stone peak, because too much was broken during the cutting to make the mitered edge. I'm a little bummed, but mostly pleased with the surface (which is the important part) thus far.

We got the IKEA shelves that are pictured in the butlers pantry photo I posted when we were on holiday in Melbourne, Australia. We don't have IKEA here in New Zealand! Hubby is going back over in May/June so will get him to get more of that sort of thing when there. We would pay about 4x the price for that sort of thing here in NZ. I need to work out what I will do now where the fridge was and there is the angle change (does that make sense?).

Normally a hot tub comes with a means of heating the water, and maintaining it without having to empty the water. This is where water filtration and disinfection methods are worth it and less wasteful. It really doesn't matter whether it is stainless steel or not: you are heating up water to levels that naturally promote bacteria and algae. Hence the NEED for some type of disinfection - which can range from tossing in a chlorine table to add ozone or other types. I suggest you purchase a book entitled "What colour is Your Swimming Pool" 2003 edition. It will give you a practical guide to what you are looking for to maintain your spa tub and why you need to do it.

This is a kitchen going into a dog kennel building so I'm not too worried about resale. My dogs are raw fed and so I spend quite a bit of time prepping food, washing bowls, etc. I'm only 5'6" but I've been doing these tasks in our house... in our current kitchen which has counters at 35 1/2"... and my back is constantly killing me after I get done. I've purchased a long stainless steel counter top for the kennel (with built in sinks) but plan on the cabinets underneath being custom built. Just can't figure out what height. I was wondering... if I'm sitting at a table (which is comfortable for me to work at for hours on end) and I measure where the table top "hits" on my body and then stand and measure the distance to the floor, it's about 41". I'm wondering if that is an indication as to where my counters in the kennel should be! Seems awfully high! I may need to take the counter top I've bought and put it on some saw horses and varying heights and work on it to see what is best before I make the call!