~$400 including expedited shipping. My GC just had his regular countertop guy do them, which wasn't great.... he had trouble making clean cuts. If I were going to do it again I would have pressed for someone with expertise to cut them. You can see in the image that the facing is not made of the stone peak, because too much was broken during the cutting to make the mitered edge. I'm a little bummed, but mostly pleased with the surface (which is the important part) thus far.

Thank you for all your comments. We have been looking at the black granite composite made by Franke but is triple the price of Blanco. Was concerned the black composite would scratch etc. will probably go two stainless steel, because as previous poster mentioned the blacks are never the same. Sure I will be back for more help or advise.

I would consider something light with some other colors to mix in like this. http://t.homedepot.com/p/Silestone-2-in-Quartz-Countertop-Sample-in-Mont-Blanc-SS-Q0220/203674451/ I like the wood paneling and would paint it a white with a warm feel to it. A white will reflect a lot of light from your large window. I wouldn't paint the window casing as it might tie in better with the rest of the house. Good luck!!

How about butcher block instead? IKEA and the big box stores sell it for countertops, the price is decent, and you won't have as many issues with buckling, water damage, or what to do with the edge as you would with the ply. If the edges of the ply get wet, or if any seam around a sink gets wet, the plywood will "blow" and you will have to replace it all, anyway.