Because the manufacturers these days want you to repurchase they use bottom of the line powder coating which is on your black taps. doesnt matter how good the construction is underneath the black coating it will rust within 3 - 12 months. the black they use is a industrial black which holds moisture (yes it is the same family of blacks on your bullbars that are on the front of your 4wd) this is designed to look good in the showroom but break down over months. Custom powder coating when done properly and with the highest materials on the market which not many use is the best cosmetic coating in the world in my opinion. it will outlast all anodizing and chrome but not raw materials like gold, silver etc etc. regards Bling Custom Coatings and soon to be Bling Home Decor.

Really old thread , so my apologies for bringing it back from the dead . If Roni is still around ( i.e. notifications get through ) -- what did you do in the end ? Personally , I don't like the red beams in the ceiling , or the blue chairs . But I quite like the warmth of the wood in the dome , so I would have done the beams or rafters ( just the few lower ones ) in a charcoal , left the floor and ceiling as they are , changed the seats to a red or burgundy -- either reupholster or replace with complete new seats . And those witches hat lightshades -- go trendy modern all round balls or similar , maybe with bright red cords and/or brass fittings or similar .

~$400 including expedited shipping. My GC just had his regular countertop guy do them, which wasn't great.... he had trouble making clean cuts. If I were going to do it again I would have pressed for someone with expertise to cut them. You can see in the image that the facing is not made of the stone peak, because too much was broken during the cutting to make the mitered edge. I'm a little bummed, but mostly pleased with the surface (which is the important part) thus far.

The all black kitchen looks scary as. Maybe because there's no lightness in there at all.