A cool, modern graphic designed runner, new door knobs and a few updated ceiling lights are a great start and easy fix to brighten and update your hallway. Have fun! {PRODUCT LINKS: http://www.atgstores.com/runners/safavieh-dhu554c-21-dhurries-runner-brown-ivory_g1461183.html http://www.atgstores.com/semi-flush-ceiling-lights/vaxcel-cr-cfu130nb-3-light-carlisle-semi-flush-ceiling-light-noble-bronze_g756367.html http://www.atgstores.com/indoor-door-handles/first-watch-security-1140-indoor-glass-knob-set_g806090.html

Hello people, Question time again. Im trying to match indoor and outdoor colour to my project around the living and pool area. I have 10 Meters of space to work with which includes 5 meters width of the living area. If i break the colours indoor v's outdoor it will make my area look smaller, more confined ? If i use polished concrete inside and try and match the colour outside, the surface will get hot. Soooooo... I have added some photos here. I went and purchased a box of man made granit tiles 80x 80cm. Keeping the shiny for the inside and tried "honing" the surface of the other tile as a test so i could use it outside and keeping the surface of the 'honed tile" slightly textured to ensure not so slippery and matching the inside colour. After coating this honed tile it has gone slightly darker which is ok. What im wanting to know, is this ok to do ? will there be any down the line effects of the tile if its outside in a wet area ? it maybe only wet for 3 months of the year for a few hours at a time. My challenge here is price V's product / Styling / practacality -Timber is too expensive for outdoor application / requires maintenance -Marble expensive -Natural stone expensive also if anyone has any solutions / kmowledge / advice it its ok to hone an indoor tile and add a protective coating for the outside. this would be much appreciated. Thanks Houzz'ers! Justin :)

When installing over top of old ceramic/porcelain be aware that you will most likely have to "sink" the old tiles in cement to do this. That means grinding down the tiles a little (rough up the surface) then the self leveling cement is poured and allowed to dry. The new floor is then laid over top. Vinyl is notorious for requiring EXTREMELY flat surface. A ceramic tile rarely has this requirement (grout lines and "high spots" around tile corners give problems). A glue in place tile is also going to have the same problems and the same solution = sinking the tiles in cement. This adds extra costs to the floor. A rigid floor like a cork floating floor can handle a bit more floor deflection than vinyl or laminate planks. If labour in your area is relatively cheap...you could probably have the tile removed and the sanding of the mortar done for the same price as coating in concrete. You will also have the luxury of being able to lay any floor you want once it is done AND you don't have to worry about increasing the floor height. It is possible to sink the ceramic in cement...but is it the most cost effective option? Maybe not.

Thanks everyone for the warnings. Honestly I had not thought that could be possible so just in case I'll gear up with a mask to avoid inhaling any of it. I will still need to remove it, but from what I read the problem with asbestos is if you sand it and make it into breathable particles, so ripping it out should be ok. I've looked up in youtubr and there seems to be a tool called mastic remover that you can put on your floor sander and it would scratch the surface removing any of that stuff.