Start with looking through photos and saving them the ones you like by adding to your ideabooks.

@thinkforothers, Ha-ha that's so funny about your American trip but yes I use the duvet as a top sheet. As for getting the dooda back into the cover, I have a pretty simple method and it doesn't take allot of effort nor does it include being swallowed up by the duvet in the process as you said ha-ha..... but there is a bit of back and forth around the bed. I flick the duvet open onto the bed, I grab the one corner of the doona head up towards the respective corner and pull the duvet back towards my hand a little too and place it down, repeat on the other side, then I grab each top corner seperately holding the doona firmly in the corner and pull it up to the headboard, whilst walking back to the end of the bed I lift the cover slightly, allowing the doona to get further swallowed up by the cover, then I'm left with slipping either corner of the doona into the duvet. I do up the buttons then holding the bottom of the duvet, I flick the cover, towards the headboard, so that the doona edges forward in the cover and even flick the doona on both sides of the bed left to right and vice versa and it's usually perfect. Its very easy doing a single doona by again spreading the duvet over the bed, grab the doona corners, one in each hand, walk them up to the corners, lay it down then pick up the dooda by the top corners and shake a few times just straight down, even stand on a safe stool or on the bed and you will usually find the duvet with eaze it's way down with just the bottom corners to slip in and again voila!!! Unfortunately, when I bought two of my duvet sets from Ezibuy, I bought NZ king which is a bit wider that an Australian king size and I didn't know that at the time and I have a bit of slack on the sides but it doesn't cause any problems and what I mean by this is, that the doona doesn't slip all the way to the left or right, it does stay in place. Hope that explanation was clear, I should do a video ha-ha Cheers, Barbara

I love your post, there is a blueprint and you are giving out details and whishes witch is making it easier for all of us to help you and your family. This floorplans reminds me a bit about my uncles house. here are some of my thoughs witch you may/or may not use. I am not sure about the NSEV directions which have a major influence in building a house. Parenting so many kids also influence the house and the lifestyle in the home. I would maybe add, or rebuild an ancle to the house prevent from wind on the terrace. Commidded as you sound i would go all in with all of your wishes. I think a big master bathroom is needed to be used as a place to relax with so much to look after. I dont now if your coing to use the door in the lundry room or in the pantry most. I thinks its best to have your garrage entry close to the pantry and kitchen. A open kitchen is also a big decision when you have so many young kids. I would maybe add a breakfast area in the kitchen. SOme other things to consider is maybe the entry and the long hall way. I think you and your family might be a bit tired of the loong hallway. if possible i would switch the entry and the office. to make the entry in to the livingroom, if le librarry is going to be used as a familyroom. A toilet should always be placed near an entry to the house. And an extra toilet is only for u to clean along the way.... I you are looking to expad the family i would maybe build a playroom in the middle of all the kids rooms. At my uncle ealier house theay had a combined office space, guest room, playroom to combind a space for all of the children and their friends to be in. As far as going to design in your home can also maybe influence the layout. I think wood floors or tiles depend on style. I Personally prefer laminet wood floors in the kitchen and entry, but you are to buy some lovely tiles now a day. Pleace ask for a new blueprint suggestion if you are up for some changes. good luck.

Have you tried hitting up the place where you bought it from or had a look at the manufacturer's website?