I would suggest you take out the cabinet that is to the right of the stove and use it elsewhere in the house -- perhaps in the bathroom or dining room with a hutch above it. Then, I would suggest you have someone install a lazy susan cabinet in the corner between the sink counter and the stove, meaning you would move the stove down a bit and have a small cabinet/counter top to the right of the stove. I would suggest you have the cabinets refinished in white and then paint the walls a pastel you like. If you would prefer white walls, then add white-painted crown molding and paint the ceiling a light neutral blue, such as Sherwin Williams Niagara Falls Blue. Then, I would suggest you choose a favorite accent color and use this sparingly in accessories like towels, pot holders, small vases or floral arrangements, and a valence above the triple windows. For a genuine 1940s look, you might have white ceramic square tiles with a rectangular red border installed as a back splash behind and above the stove. If you are replacing counter tops, I would suggest a light color such as white with a beige or light grey vein or striation for some sort of pattern. You might be able to find the same color and design in floor tile OR opt for a wood floor as another poster suggested.

As chookchook said in her recommendation about painting, put a drop cloth on the floor. Get a very safe ladder. remove the lightbulbs, and cover the outlets. Turn off the electricity to the chandelier. Then spray it with a mild cleaner (I use one I found at Target that's basically water with vinegar, until it's dripping wet. Start at the bottom and work your way up, so you don't have dirty spray dripping on the bottom of the chandelier.Work your way up and down until the dripping spray is clean. The chandelier may be gorgeous and expensive, but it seems totally out of place in the architecture of the room--more at home in a chalet than a sunny room with a window wall. I would probably try to find a way to get it removed, and sell it to someone who appreciated it better than I.

Hello There: Your home looks like it has some good bones and period features. No one has yet to comment on marrying subway tiles on lower walls, with tongue and groove cladding on upper walls of your space. I am thinking this finished look could well end up looking quite "busy." Lots of competing "grid" lines, etc. If I understand correctly, this space is actually, or ultimately will be, a bathroom. Perhaps you do not want a wood product on lower sections of the walls because of potential water damage, etc. That said, there are excellent paints, sealants, etc., that you could apply that would guard against this. If painting, using Zinsser Sealant as base coat is a good starting point. As another alternative, you could use much larger tiles on lower portion of walls, oriented vertically. I am thinking 12" x 18" (or 24") tiles. Of course, these are more challenging to install, given their greater size and therefore, weight. Despite this, if you have an excellent tiler, it can definitely be done. For example, you could choose glass tiles, either clear or coloured. Going even further, you could install glass panels to lower sections of walls. You could "back paint" them or not. You could apply paint or even wallpaper (with a wonderful design and colour way you'd likely never tire of) prior to installing glass panels. The wallpaper idea, especially if design is more curvilinear in nature, would not be competing with verticality of tongue and groove, but rather, would complement and enhance it. If beautiful wallpaper (or heck, even a mural or timeless design could be painted directly on walls) is applied and then covered with clear glass panels, the overall effect would be akin to that of an art installation. Naturally, glass panels would be considerably more expensive, but would provide a more seamless, less cluttered appearance. Should you like this idea, simply check what thickness of glass would work best, both for aesthetic and safety purposes. If you have a bit of time to shop around for best supplier and price point, you could well suss out a source that will not "break the bank!" :) To affix glass panels to the walls you want to use hardware that is anodized. As an idea, you could use anodized lug nuts that are usually used for automotive purposes. I just looked up "anodized lug nuts" and see they are available in wide array of wonderful, decorative colours. This hardware would be visibly holding your glass panels in permanent place, but they would be a small attractive design element, ultimately adding another layer of visual interest to your space. I believe glass panels would tie in very well with your great, textured/mottled glass panelled door and transom. Too, I think the overall look would achieve a really attractive marriage as various materials, along with period architectural features would "read:" old, new, and timeless. I realize this design concept may seem counterintuitive to you and/or others, but I can "see it" and think it could be just fab! All The Best, Sharon Black, interior designer and contractor

I am blown away from down under by the help that you all have freely given .... thank you sooo much indeed. who would have thought after a year of anguish that I would be put out of my misery! If I do go for the atlantic for chairs I will bring in plum touches and vice versa. Will now need to go and find some plum that closely aligns with your suggestions. Thanks for saying we can keep table! It is a good solid NZ made oak one ... chairs were all the rage back about 18 years ago! Now need to go! I will put up a pic of a rug that was quite nice but rather expensive so ... might be in an hour or so. Thank you so much again.