Try this. Hang the television to the right of the wood stove on the wall opposite the french doors. Use the wall with the high windows for a looong sofa and add two chairs across / angled slightly - low back so you can look over one to television. use console / sofa table on entry /bed door wall just past where entry door opens so you have a lay down surface. Forget glass, it isn't for this era and won't make it feel bigger. Paint ALL french doors inside and out and small windows and entry door same color and trim same color too. Try a charcoal rather than a black - something in the blue-green-gray shades like new providence navy. do all the walls in kitchen and living in a warm white - this tone has the wood as an undertone - http://www.benjaminmoore.com/en-us/paint-color/woodash then, for the cabinets . . do a bungalow thing and go deeper on the cabinets to a classic drabware tone - with the wood walls and floors / try bm bracken biscuit http://www.benjaminmoore.com/en-us/paint-color/brackenbiscuit these will all go together like gangbusters, keep it light and bright but interesting and work with a new blue green gray back door in a tone like bm beach glass http://www.benjaminmoore.com/en-us/paint-color/beachglass templeton gray as a counterpoint on some craigslist piece of furniture . . add warm undertone tan and oatmeal nubby tweed upholstery to start . . the teal navy gray will work with the black iron stove and accents without going black. start keeping the left door to the kitchen closed and get a door stop to hold the other one open permanently . . this will work because you need a little more wall to make the tv work well - in the kitchen, pull your table away from the wall just a tad - consider a padded bench on the wall to provide a kind of sitting space in there and put the chairs across - if you shift your television to the wall (high enough the heat is not an issue , you can still have big speakers work well - and remote the media equipment - run the wire and patch the holes. Hang it mid-height - eye level when you sit plus 15 degrees . . check out the amazing sconces you can put on the entry wall - shades of light petersik pendant with home-made trim wood brace to pump it out from the wall since the power is high? over the console? round wood table in middle - even a hd butcherblock round on a painted drum base in trim tone? With those tones - teal gray, biscuit, creamy off-white, muted blue-greens - paint your white chairs and a hand me down bench wythe blue and find a graphic sunbrella print with a little blue green, chocolate and orange for cushions and pad skirts with velcro at the table . . make a galvinized pipe leg / plank 1 x 12 / clear finish console for behind the door . . now you are cooking with gas . .

Thanks for the replies! My wife suggested we talk to a local real estate agent, so i think that is a good idea... just that Im not sure how helpful they are likely to be if we arent selling yet :) As for saving for our dream house, I dont disagree, however if doing this up nicely over the next ~5 years or so while we live here nets us some extra in the eventual sale, then that of course will help us as well. Interesting thing happened today actually. I got a knock on the door and one of the older neighbours asked if he could take some lemons from the tree. I of course said yes. Anyway he was telling me he had lived in the street for 40 years. I asked him if the house had always looked like this, and he said no that ~30 years ago the old old owner did a massive renovation and pulled off the timber and put up the bricks and gutted the inside of the house. Interesting stuff!

@Tribbletrouble44152k7 Trek, no not necessarily.. it fulfills it's purpose if you buy the one that is correct for what you want it for.. a bit of a catch22 and up to the store to point out that the thin stuff may dent.. in fact any of it can... there are many things that will void warranty of laminate floors.. here is a good website dealing with the cleaning and care .. http://www.baneclene.com/articles/laminate-care-consumer.html Remove shoes with spiked or damaged heels before walking on the floor. Spike or stiletto high-heel shoes may cause denting and related damage to wood floors due to the extremely high compressive force they generate. Such footwear can produce dynamic loads in excess of 1,000 pounds per square inch, even when worn by someone of slight or average build. Worth reading the whole thing.. Just worth reminding people that laminate flooring is mdf with a picture of wood printed on the surface with a couple of protective layers of clear coating over the top..it cannot be wet or steamed.. it will swell. Make sure you ask questions.. Wood vinyl planking is very durable and hardy, and bamboo is considered to be one of the strongest timbers.. if you choose to have floors redone with any of the above products please look them up on google and find out the qualities.. I vote for wood vinyl.. looks brilliant, can float or be glued (recommend glue for wet areas such as bathrooms, laundries) is hard wearing and cost is comparable with mid range wood laminate flooring and hardier. Hope that all helps. If you must have wood laminate then go for 10 - 12 mm.. anything less will flex. Must have underlay and be laid on a level floor.. There are self levelling compounds you can use to make this easier... hope all this helps.

I didn't like any of the stock standard vanities I saw being sold. By chance I happened to see a second hand vanity being sold on FB so I brought it ( see photo). I liked its shape and solid profile but didn't like its colour. I took it to a auto car spray painter and had them spray paint it in Benjamin Moore Kendall Charcoal (a greige grey). They did an awesome paint job with a mirror like finish. I brought a piece of primestone (marble look) for the top, two small towel rails to be fixed in the underside of the vanity that is sticking out so I can hang hand towels on either side. I brought a new tap for it (but kept the vessel basin). I ordered in some new legs for it online because I didn't like the legs on it (see below). Its currently at a joiners getting put together. I've actually enjoyed the process of pulling it all together. Sure by the time it has been put together I probably would have spent the same amount that it would have cost me to do a custom vanity however I think there is something to be said for re-using something a second time round rather than buying into consumerism that abounds us. All up I've spent $1,074 NZD for the vanity, the spray paint job, new legs from www.prettypegs.com, the new towel rails from Reece Plumbing & buying a new Elementi tap. That doesn't include the joiners costs - yet. I needed storage in my vanity. This one fit the bill for me. Good luck with what you choose to do! I am doing a bathroom remodel as well and enjoying it.