~$400 including expedited shipping. My GC just had his regular countertop guy do them, which wasn't great.... he had trouble making clean cuts. If I were going to do it again I would have pressed for someone with expertise to cut them. You can see in the image that the facing is not made of the stone peak, because too much was broken during the cutting to make the mitered edge. I'm a little bummed, but mostly pleased with the surface (which is the important part) thus far.

It sounds like importing it is the only way to go. Hopefully you no longer suffer from kitchen envy.

I could see doing something like French doors with opaque glass so the lite could come thru to the rest of the house. Also double French doors would allow you to open the area up completely whilst doing laundry. You could even leave everything where it is (dryer) and build some storage on the left side. I would image the sink would be very useful - I'd be lost without mine in the laundry room.

Hi Margaret, Kitchens have a lot of options so it's good to speak to your kitchen specialist about how you use your kitchen as drawer sizes tend to be influenced by type of item you are storing and which zone. DYNAMIC SPACE are Blum's ideas for practical kitchens, you can check out the zone planner, cabinet solutions and tips in our kitchen ideas section of our website. Think about the items you desire to store in your new kitchen in the following 5 zones and this will help you create a brief for your designer: Consumables, non-consumables, cleaning, preparation and cooking. Examples: 450 mm wide is a common width for a bench height rubbish bin solution with SERVO-DRIVE uno 600 mm is great width for a SPACE TOWER pantry 900 mm is a dream cutlery, utensil, plate or pot drawer Click for our NZ Kitchen Designer and Manufacturer Directory. All the best for your new kitchen. Regards, Sophie Blum NZ