Hello There: Your home looks like it has some good bones and period features. No one has yet to comment on marrying subway tiles on lower walls, with tongue and groove cladding on upper walls of your space. I am thinking this finished look could well end up looking quite "busy." Lots of competing "grid" lines, etc. If I understand correctly, this space is actually, or ultimately will be, a bathroom. Perhaps you do not want a wood product on lower sections of the walls because of potential water damage, etc. That said, there are excellent paints, sealants, etc., that you could apply that would guard against this. If painting, using Zinsser Sealant as base coat is a good starting point. As another alternative, you could use much larger tiles on lower portion of walls, oriented vertically. I am thinking 12" x 18" (or 24") tiles. Of course, these are more challenging to install, given their greater size and therefore, weight. Despite this, if you have an excellent tiler, it can definitely be done. For example, you could choose glass tiles, either clear or coloured. Going even further, you could install glass panels to lower sections of walls. You could "back paint" them or not. You could apply paint or even wallpaper (with a wonderful design and colour way you'd likely never tire of) prior to installing glass panels. The wallpaper idea, especially if design is more curvilinear in nature, would not be competing with verticality of tongue and groove, but rather, would complement and enhance it. If beautiful wallpaper (or heck, even a mural or timeless design could be painted directly on walls) is applied and then covered with clear glass panels, the overall effect would be akin to that of an art installation. Naturally, glass panels would be considerably more expensive, but would provide a more seamless, less cluttered appearance. Should you like this idea, simply check what thickness of glass would work best, both for aesthetic and safety purposes. If you have a bit of time to shop around for best supplier and price point, you could well suss out a source that will not "break the bank!" :) To affix glass panels to the walls you want to use hardware that is anodized. As an idea, you could use anodized lug nuts that are usually used for automotive purposes. I just looked up "anodized lug nuts" and see they are available in wide array of wonderful, decorative colours. This hardware would be visibly holding your glass panels in permanent place, but they would be a small attractive design element, ultimately adding another layer of visual interest to your space. I believe glass panels would tie in very well with your great, textured/mottled glass panelled door and transom. Too, I think the overall look would achieve a really attractive marriage as various materials, along with period architectural features would "read:" old, new, and timeless. I realize this design concept may seem counterintuitive to you and/or others, but I can "see it" and think it could be just fab! All The Best, Sharon Black, interior designer and contractor

Thanks :) Yeah decided to go with tile. So sand cement is ok over existing tiles if I prep them first? Only problem is, the new pad can only be about 30mm at it's thickest (leaving up to 15mm for tiles) otherwise it'll end up being higher than the hallway floor. So I either need to make the fall shallower or not bother with the waste and make it all level. If I made it level, could I use levelling compound at that thickness or would deck mud/sand cement be the best option? Also, should I be putting in mesh for strength? (I know I should (and will) ask the local hardware what they suggest, but it's great to have suggestions from the Houzz community also)

HI Madison There are pros and cons for every situation, but you need to work out what is best for your lifestyle. Personally, I agree with the carpet in the living room, and hard flooring in the kitchen/dining areas. All you need to do is work out your demarcation points (where carpet will meet hard flooring). A great retailer should be able to visit you at home, discuss options, give you pricing and away you go! (Us if you are in Auckland :) ) With littlies, I'd suggest a vinyl plank.....other posts will tell you I'm a big fan of it, but with kids, toys, mess, liquids etc, vinyl planks will give you the best wear over time. They are very hard wearing (Karndean have lifetime residential warranty), easy to keep clean, and waterproof - can be installed in all wet areas. Timber flooring, depending on which you choose (real wood, engineered wood, laminate), may not be the best "fit for purpose" products in your situation. Whilst I'm not trying to champion one product over the other, having had carpet with little kids, and putting drop sheets over carpet, under highchairs, why wouldn't someone not put in vinyl planks?

A very simple layout keeping the floor space within the kitchen, the WIP takes up a lot of space with not much gain, The broom cupboard could be moved to the Laundry/entrance, narrow. If the wall has been bumped out to the eaves on the deck side giving an extra 300 depth to the kitchen you could make the island 2700 x 1200 and all drawers. The wall of narrow pantry will hold all pantry needs and more, no deep cupboards to dig into. cheers