I would suggest you take out the cabinet that is to the right of the stove and use it elsewhere in the house -- perhaps in the bathroom or dining room with a hutch above it. Then, I would suggest you have someone install a lazy susan cabinet in the corner between the sink counter and the stove, meaning you would move the stove down a bit and have a small cabinet/counter top to the right of the stove. I would suggest you have the cabinets refinished in white and then paint the walls a pastel you like. If you would prefer white walls, then add white-painted crown molding and paint the ceiling a light neutral blue, such as Sherwin Williams Niagara Falls Blue. Then, I would suggest you choose a favorite accent color and use this sparingly in accessories like towels, pot holders, small vases or floral arrangements, and a valence above the triple windows. For a genuine 1940s look, you might have white ceramic square tiles with a rectangular red border installed as a back splash behind and above the stove. If you are replacing counter tops, I would suggest a light color such as white with a beige or light grey vein or striation for some sort of pattern. You might be able to find the same color and design in floor tile OR opt for a wood floor as another poster suggested.

Hi there nicndrew -- wondering if you ever solved your venting issues if you went ahead and put your range into the fireplace. We have a similar issue - 140 year old victorian and the only realistic plan we can come up with for a new kitchen design is to put our range into an existing fireplace. Our floorplan is constrained by a stairwell as well as a couple of weight bearing walls so we need to work with what we have...I am hoping we can vent up and out the side of the house -- four flues in this chimney but the kitchen flue is closest to the exterior wall. The contractor is coming to take a look on Saturday but would love to gather some suggestions before then.

Yes, measurements would help. Thank you aldrea1 for other explanation, though. That helps too. It sounds like you are going into a total gut-job! I love this! Great opportunity for your creativity. Also, it looks like you have a petite sized stove. With total remodel you can upgrade to a standard size range. Is this part of your plan? Are you going to replace any appliances? It would be good for you to keep sink and stove in original locations. It is complicated to move the stove's exhaust fan and the sink's plumbing. Not impossible, but probably $$$$$$$ and a lot of hassle…. So, I would start planning with those items--stove and sink on current walls. Wherever you put your refrigerator, it would be best to be sure side view is hidden. If refrigerator stays in current position, you could make peninsula a little smaller, so wall on the right of kitchen entrance could extend further and hide refrigerator edge----Or, move refrigerator to another location… Not too far from sink and counters, though. That would cause you inconvenience. You want a work triangle with not that many steps in-between. Do you currently have a dishwasher? Or are you planning to add one? Not much creativity in placement of a dishwasher---needs to be near water source and drain.. Are you doing the work yourselves or hiring a contractor?

Heating sources here in New Zealand are typically Heat Pump or woodburner. I see a heat pump merely blowing dirt and dust/hair everywhere... keeping it in the air... and distributing it all over. I've run across this: www.thermaskirt.com which is very interesting. It's like a radiator, using hot water to heat, but on each of the walls, at floor (skirting) level. Since we have 3.3m (11ft) ceilings in this addition, it might be the most effective at providing heat where we need it without blowing dirt/dust around.