I think it is awesome to give a piece of furniture a new life. It is sometimes a bit daunting to take a paint brush to a piece made from genuine old timber but if you are going to get many more years of life and enjoyment out of it I think it is better than dumping it. I believe it shows your love. jbof4 I started with a heat gun to remove most of the many layers of paint, (some are easier than others to strip this way). Then I used an orbital sander and sanded and sanded and sanded. You might also try liquid paint stripper although I find this very messy. I believe you can also get them professionally stripped. Good luck with the resurrection, go for it what have you got to lose.

Try this. Hang the television to the right of the wood stove on the wall opposite the french doors. Use the wall with the high windows for a looong sofa and add two chairs across / angled slightly - low back so you can look over one to television. use console / sofa table on entry /bed door wall just past where entry door opens so you have a lay down surface. Forget glass, it isn't for this era and won't make it feel bigger. Paint ALL french doors inside and out and small windows and entry door same color and trim same color too. Try a charcoal rather than a black - something in the blue-green-gray shades like new providence navy. do all the walls in kitchen and living in a warm white - this tone has the wood as an undertone - http://www.benjaminmoore.com/en-us/paint-color/woodash then, for the cabinets . . do a bungalow thing and go deeper on the cabinets to a classic drabware tone - with the wood walls and floors / try bm bracken biscuit http://www.benjaminmoore.com/en-us/paint-color/brackenbiscuit these will all go together like gangbusters, keep it light and bright but interesting and work with a new blue green gray back door in a tone like bm beach glass http://www.benjaminmoore.com/en-us/paint-color/beachglass templeton gray as a counterpoint on some craigslist piece of furniture . . add warm undertone tan and oatmeal nubby tweed upholstery to start . . the teal navy gray will work with the black iron stove and accents without going black. start keeping the left door to the kitchen closed and get a door stop to hold the other one open permanently . . this will work because you need a little more wall to make the tv work well - in the kitchen, pull your table away from the wall just a tad - consider a padded bench on the wall to provide a kind of sitting space in there and put the chairs across - if you shift your television to the wall (high enough the heat is not an issue , you can still have big speakers work well - and remote the media equipment - run the wire and patch the holes. Hang it mid-height - eye level when you sit plus 15 degrees . . check out the amazing sconces you can put on the entry wall - shades of light petersik pendant with home-made trim wood brace to pump it out from the wall since the power is high? over the console? round wood table in middle - even a hd butcherblock round on a painted drum base in trim tone? With those tones - teal gray, biscuit, creamy off-white, muted blue-greens - paint your white chairs and a hand me down bench wythe blue and find a graphic sunbrella print with a little blue green, chocolate and orange for cushions and pad skirts with velcro at the table . . make a galvinized pipe leg / plank 1 x 12 / clear finish console for behind the door . . now you are cooking with gas . .

Hello people, Question time again. Im trying to match indoor and outdoor colour to my project around the living and pool area. I have 10 Meters of space to work with which includes 5 meters width of the living area. If i break the colours indoor v's outdoor it will make my area look smaller, more confined ? If i use polished concrete inside and try and match the colour outside, the surface will get hot. Soooooo... I have added some photos here. I went and purchased a box of man made granit tiles 80x 80cm. Keeping the shiny for the inside and tried "honing" the surface of the other tile as a test so i could use it outside and keeping the surface of the 'honed tile" slightly textured to ensure not so slippery and matching the inside colour. After coating this honed tile it has gone slightly darker which is ok. What im wanting to know, is this ok to do ? will there be any down the line effects of the tile if its outside in a wet area ? it maybe only wet for 3 months of the year for a few hours at a time. My challenge here is price V's product / Styling / practacality -Timber is too expensive for outdoor application / requires maintenance -Marble expensive -Natural stone expensive also if anyone has any solutions / kmowledge / advice it its ok to hone an indoor tile and add a protective coating for the outside. this would be much appreciated. Thanks Houzz'ers! Justin :)

Thanks for the replies! My wife suggested we talk to a local real estate agent, so i think that is a good idea... just that Im not sure how helpful they are likely to be if we arent selling yet :) As for saving for our dream house, I dont disagree, however if doing this up nicely over the next ~5 years or so while we live here nets us some extra in the eventual sale, then that of course will help us as well. Interesting thing happened today actually. I got a knock on the door and one of the older neighbours asked if he could take some lemons from the tree. I of course said yes. Anyway he was telling me he had lived in the street for 40 years. I asked him if the house had always looked like this, and he said no that ~30 years ago the old old owner did a massive renovation and pulled off the timber and put up the bricks and gutted the inside of the house. Interesting stuff!