Hello There: Your home looks like it has some good bones and period features. No one has yet to comment on marrying subway tiles on lower walls, with tongue and groove cladding on upper walls of your space. I am thinking this finished look could well end up looking quite "busy." Lots of competing "grid" lines, etc. If I understand correctly, this space is actually, or ultimately will be, a bathroom. Perhaps you do not want a wood product on lower sections of the walls because of potential water damage, etc. That said, there are excellent paints, sealants, etc., that you could apply that would guard against this. If painting, using Zinsser Sealant as base coat is a good starting point. As another alternative, you could use much larger tiles on lower portion of walls, oriented vertically. I am thinking 12" x 18" (or 24") tiles. Of course, these are more challenging to install, given their greater size and therefore, weight. Despite this, if you have an excellent tiler, it can definitely be done. For example, you could choose glass tiles, either clear or coloured. Going even further, you could install glass panels to lower sections of walls. You could "back paint" them or not. You could apply paint or even wallpaper (with a wonderful design and colour way you'd likely never tire of) prior to installing glass panels. The wallpaper idea, especially if design is more curvilinear in nature, would not be competing with verticality of tongue and groove, but rather, would complement and enhance it. If beautiful wallpaper (or heck, even a mural or timeless design could be painted directly on walls) is applied and then covered with clear glass panels, the overall effect would be akin to that of an art installation. Naturally, glass panels would be considerably more expensive, but would provide a more seamless, less cluttered appearance. Should you like this idea, simply check what thickness of glass would work best, both for aesthetic and safety purposes. If you have a bit of time to shop around for best supplier and price point, you could well suss out a source that will not "break the bank!" :) To affix glass panels to the walls you want to use hardware that is anodized. As an idea, you could use anodized lug nuts that are usually used for automotive purposes. I just looked up "anodized lug nuts" and see they are available in wide array of wonderful, decorative colours. This hardware would be visibly holding your glass panels in permanent place, but they would be a small attractive design element, ultimately adding another layer of visual interest to your space. I believe glass panels would tie in very well with your great, textured/mottled glass panelled door and transom. Too, I think the overall look would achieve a really attractive marriage as various materials, along with period architectural features would "read:" old, new, and timeless. I realize this design concept may seem counterintuitive to you and/or others, but I can "see it" and think it could be just fab! All The Best, Sharon Black, interior designer and contractor

I recently saw this episode of Ask This Old House where they demonstrated painting tiles - especially as a solution to get one through till an entire redo is possible. http://www.thisoldhouse.com/toh/tv/ask-toh/video/0,,20902001,00.html Looks like you are doing a great job!

Get the professional sander guys in to repair the living areas and kitchen but don't go too dark with the stain as it will kill the lovely grain in the matai. I'm thinking a couple of tones richer than the timber knots showing in your photo, definitely no yellow tone at all. In NZ stepping on to carpet especially in a kiwi winter is so much nicer than a cold floor board shock!!! A nice area rug for the lounge and you're done.

Moss. Preferably the thick dense dark green kind of moss that looks like a carpet that grows on the north side of embankments where little sun reaches. How close is your nearest state or national forest or, in the alternative, the nearest dirt road with an embankment that gets little if any sun because of shade trees. Take a drive and/or walk and see what kinds of moss you can find and take some pics. A dozen or so pieces would likely be all you need to get it started because, with the right conditions -- shade and moisture -- it spreads. (Ferns like shade but usually do better with drainage. Moss likes damp but will not grow in a puddle.) Where you have windows, you could create a "view" : With a concrete planter (or on concrete pavers set a large clay planter) with a trellis with English ivy. Alternately, you could buy your own pieces of exterior grade plywood and use deck screws to affix them to the fence posts and horizontal supports of the fence and decorate them w/paint and/or planters and/or metal sculpted art --- get creative.