We used corrugated metal for our woodstove surround -- talk about a gathering place for dirt! We just use the shop vac around the bottom to clean up. We don't have any dogs, but I'd imagine that it would collect just as much fur as any place where the wall meets the floor. We also have a bit of an accent area in our kitchen with the metal as well -- it is harder to clean with the floor vacuum, but any nozzle attachment gets the job done in a snap.

@thinkforothers, Ha-ha that's so funny about your American trip but yes I use the duvet as a top sheet. As for getting the dooda back into the cover, I have a pretty simple method and it doesn't take allot of effort nor does it include being swallowed up by the duvet in the process as you said ha-ha..... but there is a bit of back and forth around the bed. I flick the duvet open onto the bed, I grab the one corner of the doona head up towards the respective corner and pull the duvet back towards my hand a little too and place it down, repeat on the other side, then I grab each top corner seperately holding the doona firmly in the corner and pull it up to the headboard, whilst walking back to the end of the bed I lift the cover slightly, allowing the doona to get further swallowed up by the cover, then I'm left with slipping either corner of the doona into the duvet. I do up the buttons then holding the bottom of the duvet, I flick the cover, towards the headboard, so that the doona edges forward in the cover and even flick the doona on both sides of the bed left to right and vice versa and it's usually perfect. Its very easy doing a single doona by again spreading the duvet over the bed, grab the doona corners, one in each hand, walk them up to the corners, lay it down then pick up the dooda by the top corners and shake a few times just straight down, even stand on a safe stool or on the bed and you will usually find the duvet with eaze it's way down with just the bottom corners to slip in and again voila!!! Unfortunately, when I bought two of my duvet sets from Ezibuy, I bought NZ king which is a bit wider that an Australian king size and I didn't know that at the time and I have a bit of slack on the sides but it doesn't cause any problems and what I mean by this is, that the doona doesn't slip all the way to the left or right, it does stay in place. Hope that explanation was clear, I should do a video ha-ha Cheers, Barbara

Hello There: Your home looks like it has some good bones and period features. No one has yet to comment on marrying subway tiles on lower walls, with tongue and groove cladding on upper walls of your space. I am thinking this finished look could well end up looking quite "busy." Lots of competing "grid" lines, etc. If I understand correctly, this space is actually, or ultimately will be, a bathroom. Perhaps you do not want a wood product on lower sections of the walls because of potential water damage, etc. That said, there are excellent paints, sealants, etc., that you could apply that would guard against this. If painting, using Zinsser Sealant as base coat is a good starting point. As another alternative, you could use much larger tiles on lower portion of walls, oriented vertically. I am thinking 12" x 18" (or 24") tiles. Of course, these are more challenging to install, given their greater size and therefore, weight. Despite this, if you have an excellent tiler, it can definitely be done. For example, you could choose glass tiles, either clear or coloured. Going even further, you could install glass panels to lower sections of walls. You could "back paint" them or not. You could apply paint or even wallpaper (with a wonderful design and colour way you'd likely never tire of) prior to installing glass panels. The wallpaper idea, especially if design is more curvilinear in nature, would not be competing with verticality of tongue and groove, but rather, would complement and enhance it. If beautiful wallpaper (or heck, even a mural or timeless design could be painted directly on walls) is applied and then covered with clear glass panels, the overall effect would be akin to that of an art installation. Naturally, glass panels would be considerably more expensive, but would provide a more seamless, less cluttered appearance. Should you like this idea, simply check what thickness of glass would work best, both for aesthetic and safety purposes. If you have a bit of time to shop around for best supplier and price point, you could well suss out a source that will not "break the bank!" :) To affix glass panels to the walls you want to use hardware that is anodized. As an idea, you could use anodized lug nuts that are usually used for automotive purposes. I just looked up "anodized lug nuts" and see they are available in wide array of wonderful, decorative colours. This hardware would be visibly holding your glass panels in permanent place, but they would be a small attractive design element, ultimately adding another layer of visual interest to your space. I believe glass panels would tie in very well with your great, textured/mottled glass panelled door and transom. Too, I think the overall look would achieve a really attractive marriage as various materials, along with period architectural features would "read:" old, new, and timeless. I realize this design concept may seem counterintuitive to you and/or others, but I can "see it" and think it could be just fab! All The Best, Sharon Black, interior designer and contractor

Thanks for the replies! My wife suggested we talk to a local real estate agent, so i think that is a good idea... just that Im not sure how helpful they are likely to be if we arent selling yet :) As for saving for our dream house, I dont disagree, however if doing this up nicely over the next ~5 years or so while we live here nets us some extra in the eventual sale, then that of course will help us as well. Interesting thing happened today actually. I got a knock on the door and one of the older neighbours asked if he could take some lemons from the tree. I of course said yes. Anyway he was telling me he had lived in the street for 40 years. I asked him if the house had always looked like this, and he said no that ~30 years ago the old old owner did a massive renovation and pulled off the timber and put up the bricks and gutted the inside of the house. Interesting stuff!